Swimming pool water pumps are circulating water equipment, also known as swimming pool circulating pumps. It is one of the important pieces of equipment for swimming pool engineering, and it is a must-have guarantee for the circulating water supply of the swimming pool. Therefore, the normal use and maintenance of swimming pool pumps in daily work are very necessary. Check the following tips from pool pump manufacturer.

Swimming pool water pumps are equipped with filter sand tanks so that while the water is circulating, the swimming pool can be cleaned daily.

1. Check before starting the swimming pool pump:

1) adjust the filter sand tank to filter state;

2)Check the swimming pool water pump valve

3) Check whether the hair collector is blocked and there is air, if there is, clean it in time;

4) Check whether the tank cover is leaking (the tank cover cannot be leaked, it must be tightened);

5)Inspect the dosing tank, check whether there is air accumulated in the main return water pipeline, if any, it must be removed through the drain valve.

2. Startup operation of swimming pool water pump:

First, turn on a swimming water pump motor. After the water pump motor is running normally, turn on the pool pump that needs to be used. Of course, if the standby pool pump is kept for swimming, it does not need to be turned on.

3. Observation:

It is not completed after starting up, we have to observe whether the swimming pool pump is operating normally:

1)Record the pressure gauge index on the filter;

2)Check whether backwashing is necessary;

3)After checking the operation of the water pump, whether it runs smoothly and without noise;

4)Check whether each dosing system is operating normally;

5)Go to the swimming pool and visually check whether the water is flowing out of the water inlets.

In short, it is to check whether all its components are normal. If a problem is found, it is necessary to find the cause of the problem and solve it

More note for swimming pool filter pump:

Swimming pool water pumps have many functions. Different functions require different aspects to be paid attention to. For example, the filter function needs to pay attention to if there is under blockage, whether there is aeration, etc. Water filter backwash function: we need to see that the pressure gauge on the sand tank has a reading of 2.5kg/cm² or more, and the sand tank needs to be back washed immediately. Then turn it on according to the instructions, observe the clear water mirror during use, and turn off the backwash pump when the water is clean and not turbid: try to prevent the pool pump from being interrupted during the draining process.

Swimming pool water pump maintenance:

a. Check frequently and clean the sand tank regularly;

b. Regularly check the seal ring of the pump headcover. If it is damaged, please replace it in time;

c. Keep the motor of swimming pool filter pump clean and keep the motor air outlet unobstructed;

d. In emergencies, the shaft sealing ring of the motor will be worn out and it should be replaced in time;

e. In winter, the water in the pool pump head should be removed, the inside and outside of the pool pump should be cleaned, and the swimming pool filter pump should be stored in a dry and well-ventilated room.

More info about the swimming pool filter pump from swimming pool pump manufacturer, stay tuned.